Y50

In order to activate the Ambient Awareness, press the AA button which is located under the power button on the RIGHT ear cup. A confirmation sound is heard and the ambient microphones are being switched on. The volume of the music will decrease and the sounds of the outside environment will increase so you can hear what goes on around you. When Ambient Aware is activated, the Blue LED on the power button will switch to a White LED light.

The Y500 headphones do not support Apt-X audio codec. However, they do support AAC audio codec.

The Y500 features the speed charge (5 min charging time = 1 Hour Playtime) In order to charge the headphones, use the micro USB charger that is included in the packaging. The charging port is located at the bottom of the RIGHT ear cup. Once the headphones are charging, you will see a solid red light next to the port. Once the headphones are fully charged, the red light indicator will turn off. Please Note: You cannot use the headphones via BT while they are charging. However, you can use the headphones via audio cable while charging.

In order to power on and pair the Y500, make sure that the device you are attempting to connect to has the BT on and is in search mode. Move the ON/OFF button from its OFF position to its ON position, which is the middle of the cutout located on the RIGHT ear cup. It will remain there, and the headphones are now ON. The blue LED will start blinking, indicating that Bluetooth pairing is possible. If you need to reset the BT pairing, move the ON/OFF button against the spring load button to the opposite position of the OFF position, and keep it there for 4- 5 seconds. Now the BT system is reset, and new pairing is possible. Please Note: The Y500 features Multi-point Connectivity which allows you to switch from two different devices.

In order to skip the tracks on the Y500 headphones, slide and hold Volume Up (to skip forward) or Volume Down (to skip backwards) for 3 seconds. These buttons are located on the LEFT ear cup.

Yes, press and hold the play/pause button for a few seconds. This will activate SIRI on your Apple phone, if the SIRI function has been enabled on the phone.

Unfortunately, the Y50BT headphones cannot be paired to multiple devices at the same time.

Yes, the Y50BT volume controls are located on the bottom of the right ear cup. You also have the power/pause/play and track controls located on the bottom right ear cup of the headphones.

The red diode that lights up when charging begins will go out again when charging is complete.

The red light in the charging status LED on the right cup will turn off.

This is a wireless headphone and also comes with a detachable audio cable that you can plug into your device.